Automatic U-shaped air duct production line – automatic air duct production line six lines of exquisite technology [Air duct production line U-shaped six lines of air duct production line U-shaped five lines] Automatic air duct production super six lines is the latest type of air duct automatic processing production line. It sets a variety of functions in one, fixed length sheet uncoiling material; Can directly complete flat, L – shaped right edge, joint Angle; Common plate flanges, C-bone flanges or Angle flanges are completed automatically. Is the current domestic complete functions, high performance, high degree of automation of a new kind of duct automatic production line, all the production speed of up to 15 m/min, production efficiency is significantly higher than other similar equipment, open book at the end of the duct from sheet metal roll bone, TDF flange, C bone flange or bend all automation (Angle steel flange).
Automatic duct production line six, according to customer requirements, the design adopts u-shaped structure, saves the production site, also reduce the sheet metal transfer time, high production efficiency (about 20 to 23 seconds can be processed under a 800 mm L sheet), after folding servo manipulator positioning, positioning precision, especially in the “L” type pipe machining, obvious advantages. Only one operator and two people take out the pipe. This production line features: small volume, low energy consumption, easy to move, high efficiency and other advantages, can produce all kinds of specifications can be factory rectangular duct. The design adopts the domestic and foreign advanced production standards of air duct, and the computer control system adopts an independent operating platform. The control system has a closed-loop feedback system, and an industrial servo motor ensures smooth and accurate operation.
Two, technical parameters
01) Galvanized sheet, stainless steel
02) Thick Galvanized sheet (0.5 ~ 1.2mm) Stainless steel (0.5 ~ 0.6mm)
03) Coil width 1000-1600mm (maximum width)
04) Running speed 15m/min
05) sheet 4000 mm
06) Minimum sheet material 150x150mm
07) Sheet length error range ±0.5mm/m
08) Air duct bending error range ±0.5mm/m
09) Standard “V” type of reinforcement (slope spacing: 210mm)
10) Control system full computer numerical control
11) Main power supply 380V 50Hz 3 phase
12) The production line power is about 30KW
13) Operating power supply 220V 50Hz 3 phase
14) The maximum hydraulic pressure is 14MPa
15) Air pressure 0.6mpa
16) The operating mode of the equipment is U-shaped
